Yahoo 知識+ 將於 2021 年 5 月 4 日 (美國東岸時間) 停止服務,而 Yahoo 知識+ 網站現已轉為僅限瀏覽模式。其他 Yahoo 資產或服務,或你的 Yahoo 帳戶將不會有任何變更。你可以在此服務中心網頁進一步了解 Yahoo 知識+ 停止服務的事宜,以及了解如何下載你的資料。

bathroom outlet with a reset button suddenly doesn't work. Why and how to fix it?

11 個解答

相關度
  • I care
    Lv 7
    2 年前
    最愛解答

    Recent experienced this issue......I just wasn't pushing in the reset button hard enough. I feel your frustration...….but work harder in pushing in the reset button...…….good luck.

  • ET
    Lv 5
    2 年前

    Plug hair dryer in, and turn it on. Press the red button.

    If it still doesn't work, go to panel box, and turn that circuit off. Remove the outlet. Take it to the hardware store. Buy a knew one. Install it. Turn the circuit on. Press the red button, if necessary.

  • 2 年前

    I had this problem once and the circuit breaker was still on. Got a new GFCI outlet and it would work for a while and quit again. Turned out there should not have been a GFCI in the bathroom where it was. The first outlet of the circuit was in the garage and was GFCI also. Having two GFCI's in the same circuit is apparently not good. Took out the redundant one down the line one and problem solved.

    資料來源: Ground fault outlet do fail on their own sometimes and are not cheap.
  • GEEGEE
    Lv 7
    2 年前

    Thank you everyone for your suggestions. I have tried resetting it without success. I will check the fuse box later today.

  • 2 年前

    Did you try resetting it?

  • 2 年前

    The test button on the leak detection (gfci) receptacle is there because they fail. A failed test indicates the receptacle needs to be replaced.

    Before replacing it would be good to make sure no circuit breakers are tripped.

  • 2 年前

    most likely -- check the breaker in the box that controls it. you may need to unplug items before it will work again.

    if unplugging everything on the circuit that isn't working doesn't fix the breaker issue, then an electrician is needed. breakers in the box can and do go bad and need replacing. That isn't a task for the ordinary homeowner. [of course, if you're a tenant it's the landlord's problem at that point]

    資料來源: grampa
  • 2 年前

    That' button' is the ground fault interruptor. It will pop out when that circuit breaker has been tripped. The rest button is meant to save you from having to go to the house's electrical box to reset the circuit breaker. When the rest button will not reset, first, check the electrical box to see if the circuit there was tripped. If it was, reset it and see what happens. Push the test button and then the rest button. If it soesn't reset, then the unit should be replaced.

  • Carson
    Lv 6
    2 年前

    That's a GFI Ground Fault Interrupter. Unplug devices and reset it by pressing the black button firmly. if it doesn't reset go to your fuse box and see if a breaker has tripped. Itll look half switched on. Push towards off push towards on.

    GFI switches can and do wear out. If it will not reset the outlet needs to be replaced.

  • y
    Lv 7
    2 年前

    reset, check breaker, replace.

還有問題嗎?立即提問即可得到解答。