Yahoo 知識+ 將於 2021 年 5 月 4 日 (美國東岸時間) 停止服務,而 Yahoo 知識+ 網站現已轉為僅限瀏覽模式。其他 Yahoo 資產或服務,或你的 Yahoo 帳戶將不會有任何變更。你可以在此服務中心網頁進一步了解 Yahoo 知識+ 停止服務的事宜,以及了解如何下載你的資料。

Lawn mower won't start/stay running?

My push mower will not run properly this year. 2 years old, Murray with a Briggs and Stratton engine - http://www.walmart.com/ip/Murray-22-Gas-Powered-La...

Earlier this year, it was hard to start and had significantly less power than before - quitting frequently in grass that should have been no problem. Now it is hard to start, and will only run a few minutes, missing and making a popping sound. I've replaced the spark plug, removed and cleaned the carburetor, poked and prodded around it high and low, it is beyond my diagnostic abilities.

Any ideas? I'm expecting a dialogue here, so ask for any additional details that may help figure this out.

更新:

The carb is as clean as I can get it, already taken it apart for cleaning twice. Fuel is definitely getting to the carb, I forgot about draining the tank the first time I took it apart and got soaked in gas. Loosening/removing the gas cap doesn't help, so I don't think the vent is plugged. Additionally, to get it to start requires a generous amount of priming.

更新 2:

In response to further information, I've pulled the primer bulb. The bulb is held in by a hard white plastic ring, the ring appears warped (not perfectly circular. Could this be enough to cause the problem? Replacing it before replacing the carb would be a cheap experiment to see if it helps.

3 個解答

相關度
  • Jim W
    Lv 7
    5 年前
    最愛解答

    Maybe the fuel is not reaching the carburetor, that is sometimes caused by a plugged vent in the fuel cap. Remove the line from the carburetor and check the flow. Then I would check for proper compression. Another thing is to clean the blade and make sure it was sharp. When you removed carburetor the gasket should also be replaced. Briggs has a Service and Maintenance manual that will give specifications for their engines. Try Amazon for one. The loss of power may be caused by timing or governor problems. the governor linkage may need oil to move free, the timing needs the manual and a timing light.

    With the additional information about the priming it is certain that the carburetor is the problem. I would now suggest a replacement unit probably less than $50. There is a possibility that the primer bulb is leaking and should be replaced. Any gasket that is in the intake system will give problems.

  • renpen
    Lv 7
    5 年前

    What you describe sounds like a dirty carburetor. That is the most common issue with small engines. The carb needs to be removed and taken apart then soaked in a quality parts cleaner. Sometimes you can get by with a spray can of carb cleaner. The ignition timing doesn't sound like the issue to me. Timing is controlled by a key between the flywheel and the crankshaft. Hitting rocks etc can shear that key. But the starting and running for a few minutes doesn't sound like the symptoms of a sheared key. I think you need to do a better cleaning of the carburetor.

  • 4 年前

    If you're too stupid to repair it, why are you also so stupid that you won't bring it to a repair shop? Those guys are much smarter than you, moron.

還有問題嗎?立即提問即可得到解答。